Allied Telesis AT-S63 - Manual (Page 543)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 543
The Web Server Configuration menu is shown in Figure 173.
Figure 173. Web Server Configuration Menu
3. Type 1 to select Status to enable or disable the web server. To
configure the web server, you must first disable it.
Toggle between the following values:
Enabled - Enables the web server. This is the default setting.
Disabled - Disables the web server. (If you are making any
changes to the web server settings, you must first disable it.)
4. Type 2 to select Mode to set the mode of the web server.
The following prompt is displayed:
Enter Web Server Mode (1 - HTTP, 2 - HTTPS):
[1 to 2] ->
5. Choose one of the following:
1 - HTTP to select the non-secure HTTP mode for the web server.
This is the default value.
2 - HTTPS to select the secure HTTPS mode. This setting activates
the SSL protocol on the web server.
When you choose HTTPS, the following prompt is displayed:
Enter SSL Key ID ->
6. Enter an SSL Key ID.
Enter the ID number of an encryption key on the switch. (To view
the encryption key IDs, refer to ”Creating an Encryption Key” on
page 559.) You must have already created the encryption key and
a certificate using the key. You must also have already added the
certificate to the certificate database.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Web Server Configuration
1 - Status ............................ Disabled
2 - Mode .............................. HTTP
3 - Port Number ....................... 80
R - Return to Previous Menu
Enter your selection?