Allied Telesis AT-S63 - Manual (Page 337)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 337
The Modify SNMPv3 Table menu is shown in Figure 108 on page
333.
4. To change the storage type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter the User Name.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
6. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 User Table to nonvolatile memory. After
making changes to an SNMPv3 User Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 User Table to nonvolatile memory. After making
changes to an SNMPv3 User Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes. Allied
Telesyn recommends this storage type.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.