Allied Telesis AT-S63 - Manual (Page 55)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 55
The following prompt is displayed:
BOOTP/DHCP (E-Enabled, D-Disabled):
4. Type E to enable BOOTP and DHCP services on the switch or D to
disable the services and press Return. The default is disabled.
Note
If you activated BOOTP/DHCP, the switch immediately begins to
query the network for a BOOTP or DHCP server. The switch
continues to query the network for its IP configuration until it
receives a response.
Any static IP address, subnet mask, or gateway address assigned to
the switch is deleted from the System Configuration menu and
replaced with the value the switch receives from the BOOTP or
DHCP server. If you later disable BOOTP and DHCP, these values are
returned to their default settings.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.