Allied Telesis AT-S63 - Manual (Page 594)

Chapter 27: PKI Certificates and SSL
594 Section IV: Security
Deleting a Certificate
The procedure in this section deletes a certificate from the certificate
database. Please note the following before performing this procedure:
❑ Deleting a certificate from the database does not delete it from
the switch. It continues to reside in the AT-S62 file system. To
completely remove a certificate from the switch, you must also
delete it from the file system. For instructions, refer to ”Copying a
System File” on page 179.
❑ You cannot delete a certificate from the database if you specified
its corresponding encryption key as the active key in the web
server configuration. The switch will consider the certificate as in
use and will not allow you to delete it. You must first configure the
web server with another encryption key pair for a different
certificate. For instructions, refer to ”Configuring the Web Server”
on page 542.
This procedure starts from the X509 Certificate Management menu. If
you are unsure how to access the menu, perform steps 1 to 4 in the
procedure ”Adding a Certificate to the Database” on page 588.
To delete a certificate from the certificate database, perform the
following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 3 to select
Keys/Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 176
on page 560.
3. From the Keys/Certificate menu, type 3 to select Public Key
Infrastructure (PKI) Configuration.
The Public Key Infrastructure (PKI) Configuration menu is shown
in Figure 182 on page 585.
4. From the Public Key Infrastructure (PKI) Configuration menu, type 2
to select X509 Certificate Management.
The X509 Certificate Management menu is shown in Figure 183
on page 585.