Allied Telesis AT-S63 - Manual (Page 212)

Chapter 12: Event Log
212 Section II: Advanced Features
Full
Displays the same information as Normal, plus the file name, line
number, and event ID. An example of Full mode is shown in Figure
63 on page 216.
6. To display events of a selected severity, type 6 to select Event
Severity.
The following prompt is displayed:
Enter Severity levels to display (ALL, E - Error, W -
Warning, I - Information, D - Debug) ->
The possible options are:
ALL
All messages of the following types are displayed.
E - Error
Only error messages are displayed. Error messages indicate that
the switch operation is severely impaired.
W - Warning
Only warning messages are displayed. These messages indicate
that an issue may require manager attention.
I - Information
Only informational messages are displayed. Informational
messages display useful information that you can ignore during
normal operation.
D - Debug
Debug messages provide detailed high-volume information that
is intended only for technical support personnel.
You can select more than one severity at a time, separated by a
comma, for example, E,W.
7. To display events of a particular AT-S63 software module, type 7 to
select Event Module.
The following prompt is displayed:
Enter Modules to display (ALL, SYSTEM, CLI, EVTLOG,
MAC, STP, VLAN, GARP, PCFG, PMIRR, PTRUNK, PSEC,
PACCESS, ACL, DOS, MGMTACL, IP, ESTACK, FILE,
IGMPSNOOP,TIME,TFTP, RRP, HTTP, TELNET, SNMP, RADIUS,
TACACS, ENCO, PKI, SSL, SSH, USER, CFG) ->
8. Enter a list of modules separated by a comma—for example, “system,
stp, ptrunk.”