Allied Telesis AT-S63 - Manual (Page 480)

Chapter 21: GARP VLAN Registration Protocol
480 Section III: VLANs
Configuring GVRP
To configure GVRP, perform the following procedure:
The timers in the following menus are in increments of centi seconds
which is a hundredth of a second.
To configure GVRP, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 135 on page
441.
2. From the VLAN Configuration menu, type 7 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 149.
Figure 149. GARP-GVRP Menu
Note
Selection 8, Configure GARP-GVRP, is not shown in the VLAN
Configuration menu when the VLAN mode is multiple VLANs.
3. Type 1 to select GVRP Status.
The following prompt is displayed:
Enter your new value (E-Enabled, D-Disabled):
4. Type E to enable GVRP or D to disable GVRP. The default setting is
disabled.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
GARP-GVRP
1 - GVRP Status ........... Disabled
2 - GVRP GIP Status ....... Enabled
3 - GVRP Join Timer ....... 20
4 - GVRP Leave Timer ...... 60
5 - GVRP Leave All Timer .. 1000
P - GVRP Port Parameters
O - Other GVRP Parameters
D - Reset GVRP to Defaults
R - Return to Previous Menu
Enter your selection?