Allied Telesis AT-S63 - Manual (Page 88)

Chapter 4: SNMPv1 and SNMPv2 Community Strings
88 Section I: Basic Operations
Modifying a Community String
To modify a community string, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 5 to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 17 on page 83.
3. From the SNMP Configuration menu, type 3 to select Configure
SNMPv1 &SNMPv2c Community.
The Configure SNMPv1 &SNMPv2c Community menu in shown in
Figure 18 on page 85.
4. From the Configure SNMPv1 &SNMPv2c Community menu, type 3 to
select Modify SNMP Community.
The Modify SNMP Community menu is shown in Figure 19.
Figure 19. Modify SNMP Community Menu
This menu lists the current community strings on the switch and
their attributes. For attribute definitions, refer to ”SNMPv1 and
SNMPv2c Overview” on page 80.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Modify SNMPv1 & SNMPv2c Community
Community Name AccessMode Status OpenAcc Manager IP Addr Trap Rec IP
------------------------------------------------------------------------
-
Private
Read|Write Enabled Yes
Public Read Enabled Yes
Private Read|Write Enabled Yes
Public Read Enabled Yes
1 - Add Attributes to Community
2 - Delete Attributes from Community
3 - Set Community Access Mode
4 - Set Community Status
5 - Set Community Open Access
U - Update Display
R - Return to Previous Menu
Enter your selection?