Allied Telesis AT-S63 - Manual (Page 373)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 373
I-Inform
Indicates this notify table is used to send inform messages. With
this message type, the switch expects a response from the host.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-NonVolatile]:
7. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 Notify Table to the configuration file. After
making changes to an SNMPv3 Notify Table entry with a Volatile
storage type, the
S - Save Configuration Changes option does not appear on the
Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 Notify Table to the configuration file. After making
changes to an SNMPv3 Notify Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes. Allied
Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field. The Active value
indicates the SNMPv3 Notify Table entry takes effect immediately.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Deleting an
SNMPv3 Notify
Table Entry
You may want to delete an entry from the Configure SNMPv3 Notify
Table menu. When you delete a Configure SNMPv3 Notify Table entry,
there is no way to undelete, or recover, the entry.
To delete an entry in the Configure SNMPv3 Notify Table menu, perform
the following procedure:
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is shown in Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 6 to select Configure
SNMPv3 Notify Table.