Allied Telesis AT-S63 - Manual (Page 330)

Chapter 18: SNMPv3
330 Section II: Advanced Features
5. To create a new user table, type 1 to select Create SNMPv3 Table
Entry.
The following prompt is displayed:
Enter User (Security) Name:
6. Enter a descriptive name of the user.
You can enter a name that consists of up to 32 alphanumeric
characters.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA, N-None]:
7. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users (SNMP entities) are authenticated with the MD5
authentication protocol after a message is received. This
algorithm generates the message digest. The user is
authenticated when the authentication protocol checks the
message digest. With the MD5 selection, you can configure a
Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
protocol after a message is received. This algorithm generates the
message digest. The user is authenticated when the
authentication protocol checks the message digest. With the SHA
selection, you can configure a Privacy Protocol.
N-None
This value represents no authentication protocol. When messages
are received, users are not authenticated. With the None
selection, you cannot configure a Privacy Protocol.
Note
You may want to assign NONE to a super user.
If you select NONE, you are prompted for the Storage Type. Go to
Step 13.
If you select MD5 or SHA, the following prompt is displayed:
Enter Authentication Password: