Allied Telesis AT-S63 - Manual (Page 589)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 589
The Add Certificate menu is shown in Figure 185.
Figure 185. Add Certificate Menu
6. Type 1 to select Certificate Name.
The following prompt is displayed:
Enter file name (*.key) ->
7. Enter a name for the certificate.
This is the name for the certificate as it will appear in the certificate
database list. You can enter up to 24 alphanumeric characters.
Spaces are allowed. No extension is needed.
You might want the name to include the filename of the
certificate in the file system. This will make it easier for you to
correlate a certificate in the database with its corresponding file in
the file system. Here is an example:
Switch 12 - sw12.cer
8. Type 2 to select (certificate) State. The possible settings are:
Trusted
This value indicates you have verified that the certificate is from a
trusted CA. This is the default.
Untrusted
This value indicates the certificate is from an untrusted CA either
because you have not verified the CA or you have verified the CA
is untrusted.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Add Certificate
1 - Certificate Name .............
2 - State ........................ Trusted
3 - Type ......................... EE
4 - File Name ....................
5 - Add Certificate
R - Return to Previous Menu
Enter your selection?