Allied Telesis AT-S63 - Manual (Page 453)

AT-S63 Management Software Menus Interface User’s Guide
Section III: VLANs 453
Deleting a VLAN
Note
To delete a VLAN, you need to know its VID. To view VLAN VIDs, refer
to ”Displaying VLANs” on page 451.
To delete a VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 135 on page
441.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
The Configure VLANs menu is shown in Figure 136 on page 442.
Note
If option 4, Configure VLANs, is not displayed in the menu if the
switch is running a multiple VLAN mode. To change a switch’s VLAN
mode, refer to ”Selecting a VLAN Mode” on page 468.
3. From the Configure VLANs menu, type 3 to select Delete VLAN.
The Delete VLAN menu is shown in Figure 141.
Figure 141. Delete VLAN Menu
4. Type 1 to select VLAN ID (VID).
The following prompt is displayed:
Enter new value -> [2 to 4094] ->
5. Enter the VID of the VLAN you want to delete. You can specify only
one VID at a time.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Delete VLAN
1 - VLAN ID (VID) ........
R - Return to Previous Menu
Enter your selection?