Allied Telesis AT-S63 - Manual (Page 448)

Chapter 19: Port-based and Tagged VLANs
448 Section III: VLANs
Enter new value -> [1 to 4096] ->
5. Enter the VID of the VLAN you want to modify.
The Modify VLAN menu expands to contain all relevant
information about the VLAN, as shown in Figure 139.
Figure 139. Expanded Modify VLAN Menu
6. Adjust the following parameters as necessary.
1 - VLAN Name
Use this selection to change the name of a VLAN. The name can be
from one to fifteen characters in length. The name should reflect
the function of the nodes that will be a part of the VLAN (for
example, Sales or Accounting). The name cannot contain spaces
or special characters, such as asterisks (*) or exclamation points (!).
When you change a VLAN’s name, observe the following
guidelines:
❑ A VLAN’s new name cannot be the same as the name of another
VLAN on the same switch. For example, if the switch already
contains a VLAN called Sales, you cannot change an existing
VLAN’s name to Sales.
❑ You cannot change the name of the Default_VLAN.
Note
A VLAN must have a name.
2 - VLAN ID (VID)
This is the VLAN’s VID value. You cannot change this value.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Modify VLAN
1 - VLAN Name .............. Sales
2 - VLAN ID (VID) .......... 3
3 - Tagged Ports ........... 7,9
4 - Untagged Ports ......... 20-24
M - Modify VLAN
R - Return to Previous Menu
Enter your selection?