Allied Telesis AT-S63 - Manual (Page 346)

Chapter 18: SNMPv3
346 Section II: Advanced Features
3. From the Configure SNMPv3 View Table menu, type 3 to select
Modify SNMPv3 Table Entry.
The Modify SNMPv3 Table menu is shown in Figure 110 on page
343.
4. To modify the storage type, type 3 to select Set Storage Type.
The following prompt is displayed:
Enter View Name:
5. Enter the View Name you want to modify.
The following prompt is displayed:
Enter View Subtree (OID format/Text Name):
6. Enter the View Subtree for this View Name.
The following prompt is displayed:
Enter Storage Type [V-Volatile, N-Nonvolatile]:
7. Select one of the following storage types for this table entry:
V - Volatile
Select this storage type if you do not want the ability to save an
entry in the SNMPv3 View Table to the configuration file. After
making changes to an SNMPv3 View Table entry with a Volatile
storage type, the S - Save Configuration Changes option does not
appear on the Main Menu.
N-NonVolatile
Select this storage type if you want the ability to save an entry in
the SNMPv3 View Table to the configuration file. After making
changes to an SNMPv3 View Table entry with a NonVolatile
storage type, the S - Save Configuration Changes option appears
on the Main Menu, allowing you to save your changes. Allied
Telesyn recommends this storage type.
8. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.