Allied Telesis AT-S63 - Manual (Page 173)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 173
page 175
Creating a Boot Configuration File
Before you begin to configure the switch with the parameter settings
that you want to save in a new boot configuration file, you should first
create the file. Configuring the parameters first and then creating the
new boot configuration file might cause you to inadvertently change a
boot configuration file that you might not want to change.
To create a boot configuration file, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown Figure 4 on page 51.
2. From the System Administration menu, type 9 to select System
Utilities.
The System Utilities menu is shown in Figure 7 on page 58.
3. From the System Utilities menu, type 1 to select File Operations.
The File Operations menu is shown in Figure 49.
Figure 49. File Operations Menu
4. From the File Operations menu, type 3 to select Create Configuration
File.
The following prompt is displayed:
Enter the file name:
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
File Operations
1 - Boot Configuration File ......... boot.cfg (Exists)
2 - Current Configuration ........... boot.cfg
3 - Create Configuration File
4 - Copy File
5 - Rename File
6 - Delete File
7 - View File
8 - List Files
R - Return to Previous Menu
Enter your selection?