Allied Telesis AT-S63 - Manual (Page 542)

Chapter 25: Web Server
542 Section IV: Security
Configuring the Web Server
This procedure explains how to enable and disable the web server and
how to configure the HTTP and HTTPS settings from a local or Telnet
management session. The default setting for the web server is enabled,
with the non-secure HTTP mode as the active web server mode.
Before you configure the web server, please note the following:
❑ You cannot make any changes to the HTTP or HTTPS settings
while the web server is enabled. You must first disable the web
server before making changes.
❑ To configure the web server for the HTTPS secure mode, you must
first create an encryption key and a certificate, and add the
certificate to the certificate database. The AT-S63 management
software does not allow you to configure the web server for the
HTTPS secure mode until those steps have been completed. For
instructions, refer to Chapter 26, ”Encryption Keys” on page 547,
and Chapter 27, ”PKI Certificates and SSL” on page 573.
❑ To make a change to an HTTP or HTTPS setting, you must perform
the entire procedure. For example, to change the port number for
HTTP, you must first disable the web server and then reselect
HTTP.
To configure the web server, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 4 to select Web Server
Configuration.