Allied Telesis AT-S63 - Manual (Page 508)

Chapter 22: Protected Ports VLANs
508 Section III: VLANs
2 - VLAN ID (VID)
This is the VLAN’s VID value. You cannot change this value.
3 - Tagged Ports
Use this selection to add or remove tagged ports from the VLAN.
You can specify the ports individually (e.g., 2,3,5), as a range (e.g.,
7-9), or both (e.g., 2,5,7-9). The new list of tagged ports will replace
the existing tagged ports.
4 - Untagged Ports
Use this selection to add or remove untagged ports from the
VLAN. You can specify the ports individually (e.g., 2,3,5), as a range
(e.g., 7-9), or both (e.g., 2,5,7-9). The new list of untagged ports will
replace the existing list of untagged ports.
5 - Protected Ports
This option cannot be changed. To convert a protected ports
VLAN into a tagged or port-based VLAN, you must first delete it
and then recreate it as a tagged or port-based VLAN.
7. After making the desired changes, type M to select Modify VLAN.
The following prompt is displayed:
Enter Uplink Ports (4 - 12) ->
This prompt will differ depending on the ports you specified as
part of the protected ports VLAN.
8. Enter the port in the VLAN that will function as the uplink port for the
different VLAN groups. You can select more than one uplink port.
The following prompt is displayed:
Enter Group Ports (4 - 11) ->
The prompt now lists the ports in the VLAN, minus the uplink port
you specified in the previous step.
9. Specify the ports of one of the groups of the protected ports VLAN.
This can be a small as one port or as many as all the remaining ports
of the VLAN. You can specify the ports of the group individually (e.g.,
2,3,5), as a range (e.g., 7-9), or both (e.g., 2,5,7-9).
The following prompt is displayed:
Enter Group Number ->
10. Enter a group number for the port(s). Each group on the switch must
be given a unique group number.