Allied Telesis AT-S63 - Manual (Page 603)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 603
Viewing or Configuring the Number of Certificates in the
Database
The maximum number of certificates you can add to the certificate
database is 12 to 256. The default value is 256. There should be little
cause or need for you to adjust this value.
To view or change the number of certificates in the certificate database,
perform the following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 3 to select
Keys/Certificates Configuration.
The Keys/Certificates Configuration menu is shown in Figure 176
on page 560. Selection 1, Maximum Number of Certificates, shows
the current setting.
Note
You can specify the distinguished name for the certificate from this
menu by selecting option 1, Distinguished Name, in the
Keys/Certificates Configuration menu and entering the name. Or,
you can wait and specify the distinguished name later in this
procedure. For information about distinguished names, refer to
”Distinguished Names” on page 576.
3. To change the maximum number of certificates, type 1 to select
Maximum Number of Certificates.
The following prompt is displayed:
Enter certificate limit -> [12 to 256] 256
4. Enter a new number and press Return.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.