Allied Telesis AT-S63 - Manual (Page 260)

Chapter 16: STP and RSTP
260 Section II: Advanced Features
4. If you selected STP as the active spanning tree protocol, go to
”Configuring STP” on page 261 for further instructions. If you selected
RSTP, go to ”Configuring RSTP” on page 267. Multiple Spanning Tree
Protocol (MSTP) is described in Chapter 17, ”MSTP” on page 277.
Note
After you have configured the spanning tree parameters, perform
steps 5 through 7 to enable spanning tree.
5. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
The following prompt is displayed:
Enter new value (E-Enable, D-Disable):
6. Type E to enable spanning tree or D to disable it. The default is
disabled.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.