Allied Telesis AT-S63 - Manual (Page 164)

Chapter 9: Port Mirroring
164 Section I: Basic Features
Modifying a Port Mirror
To modify the port mirror, perform the following procedure:
1. From the Main Menu, type 1 to select Port Configuration.
The Port Configuration menu is shown in Figure 26 on page 106.
2. From the Port Configuration menu, type 6 to select Port Mirroring.
The Port Mirroring menu is shown in Figure 47 on page 161.
3. Type 2 to select Mirror-To (Destinaton) Port.
The following prompt is displayed:
Mirror-To Port (0-24):
4. Enter the number of the port that will function as the destination port.
This is the port where the traffic from the source ports will be copied
to and where the network analyzer will be located. You can specify
only one destination port.
5. If you want to mirror the ingress (received) traffic on one or more
ports, type 3 to select Ingress(Rx) Mirror (Source Ports.
The following prompt is displayed:
Ingress Mirror Ports (01-24) (0=None):
6. Enter the ports. You can identify the ports individually (for example,
3,7,10), as a range (for example, 5-11), or both (for example, 2,4,11-14).
Entering “0” (zero) removes all ingress source ports.
7. If you want to mirror the egress (transmitted) traffic from one or more
ports, type 4 to select Egress Mirror Port.
The following prompt is displayed:
Egresss Mirror Ports (01-24) (0=None):
8. Enter the ports. Entering “0” (zero) removes all egress source ports.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.