Allied Telesis AT-S63 - Manual (Page 195)

AT-S63 Management Software Menus Interface User’s Guide
Section I: Basic Features 195
Note
You can download an AT-9400 Series configuration file only onto
other AT-9400 Series switches. Do not attempt to download the file
onto any other type of enhanced stacking switch.
The following prompt is displayed:
Do you want to show remote switch burning flash ->
[Yes/No]
7. You can respond with Yes or No to this prompt. It does not affect the
download.
The following prompt is displayed:
Do you want confirmation before downloading each switch
-> [Yes/No]
8. If you answer Yes to this prompt, the management software prompts
you with a confirmation message before downloading the file to a
switch. If you answer No, the management software does not display
a confirmation prompt before downloading.
The management software begins the download. The
management software notifies you when the download is
complete.
After the configuration file is downloaded to a switch, the AT-S63
management software places the file in its file system. To make
the file the active boot configuration file on the switch, refer to
”Setting the Active Boot Configuration File” on page 175.