Allied Telesis AT-S63 - Manual (Page 411)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 411
Modifying an
SNMPv3
Community
Table Entry
For each entry in the SNMPv3 Community Table, you can modify the
following parameters:
❑ Community Name
❑ Security Name
❑ Transport Tag
❑ Storage Type
However, you cannot modify the Community Index parameter.
Although you can display the SNMPv1 and SNMPv2c configuration
created with the procedures described in ”Creating an SNMP
Community String” on page 85, you cannot modify these Community
Table entries with the SNMPv3 Tables.
See the following procedures:
❑ ”Modifying the Community Name” on page 411
❑ ”Modifying the Security Name” on page 413
❑ ”Modifying the Transport Tag” on page 413
❑ ”Modifying the Storage Type” on page 414
Modifying the Community Name
To modify the Community Name parameter in an SNMPv3 Community
Table entry, perform the following procedure:
1. Follow steps 1 through 5 in the procedure described in ”Creating an
SNMPv3 User Table Entry” on page 328. Or, from the Main menu type
5->1->1->8->5.
The Configure SNMPv3 Table menu is displayed Figure 106 on
page 329.
2. From the Configure SNMPv3 Table menu, type 9 to select Configure
SNMPv3 Community Table.
The SNMPv3 Community Table is shown in Figure 121 on page
408.
3. From the Configure SNMPv3 Community Table, type 3 to select
Modify SNMPv3 Table Entry.