Allied Telesis AT-S63 - Manual (Page 90)

Chapter 4: SNMPv1 and SNMPv2 Community Strings
90 Section I: Basic Operations
3. If you want to remove the IP address of a management workstation
from the community string, enter the IP address at the prompt.
Otherwise, just press Return. This prompt is displayed:
Enter Trap Receiver IP Addr:
4. If you want to remove the IP address of a trap receiver from the
community string, enter the IP address at the prompt. Otherwise, just
press Return.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
3 - Set Community Access Mode
Use this option to change a community string’s Read or Read/Write
status. To use the selection, do the following:
1. From the Modify SNMP Community menu, type 3 to select Set
Community Access Mode. The following prompt is displayed:
Enter SNMP Community Name:
2. Enter the community string you want to modify. Community strings
are case sensitive. The following prompt is displayed:
Enter Access Mode [R-Read Only, W-Read/Write]:
3. Type R to change the string’s status to Read only, or W for Read/Write.
This confirmation prompt is displayed:
Do you want to change this Community Access Mode? (Y/N):
[Yes/No] ->
4. Type Y to change the string’s access mode or N to cancel the change.
5. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
4 - Set Community Status
Use this option to enable or disable a community string. When disabled,
no one can use the community string to access the switch. To use the
selection, do the following:
1. From the Modify SNMP Community menu, type 4 to select Set
Community Status. The following prompt is displayed:
Enter SNMP Community Name:
2. Enter the community string you want to modify. Community strings
are case sensitive. The following prompt is displayed:
Enter Community Status [E-Enable, D-Disable]: