Allied Telesis AT-S63 - Manual (Page 66)

Chapter 3: Basic Switch Parameters
66 Section I: Basic Features
Configuring the Console Startup Mode
You can configure the AT-S63 management software to display either
the Main Menu or the command line interface prompt whenever you
start a local or Telnet management session. The default is the command
line interface.
To change the console startup mode, perform the following procedure:
1. From the Main Menu, type 5 to select System Administration.
The System Administration menu is shown in Figure 4 on page 51.
2. From the System Administration menu, type 3 to select Console
(Serial/Telnet) Configuration.
The Console (Serial/Telnet) Configuration menu is shown in
Figure 11.
Figure 11. Console (Serial/Telnet) Configuration Menu
3. Type 1 to toggle Console Startup Mode between Menu and CLI. When
the mode is set to Menu, a management session starts by displaying
the Main Menu. When the mode is set to CLI, a management session
starts with the command line interface prompt. The system default is
CLI.
4. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
A change to the console startup mode takes effect the next time
you start a local management session.
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Console (Serial/Telnet) Configuration
1 - Console Startup Mode ............ CLI
2 - Console Disconnect Interval ..... 10 minute(s)
3 - Console Baud Rate ............... 9600
4 - Telnet Server ................... Enabled
R - Return to Previous Menu
Enter your selection?