Allied Telesis AT-S63 - Manual (Page 464)

Chapter 20: Multiple VLANs
464 Section III: VLANs
Multiple VLAN Mode Overview
The multiple VLAN modes are designed to simplify the task of
configuring the switch in network environments that require a high
degree of network segmentation. In a multiple VLAN mode, the ports on
a switch are prohibited from forwarding traffic to each other and are
only allowed to forward traffic to a user-designated uplink port. These
configurations isolate the traffic on each port from all other ports, while
providing access to the uplink port.
The AT-S63 management software supports two types of multiple VLAN
modes:
❑ 802.1Q-compliant Multiple VLAN mode
❑ Multiple VLAN mode (also referred to as non-802.1Q compliant
Multiple VLAN mode)
Each mode uses a different technique to isolate the ports and their
traffic. The first method uses VLANs while the second uses port mapping.
The uplink port is also different in each mode. In one the port is a tagged
port and in the other untagged. This is explained in the following
subsections.
Note
The multiple VLAN mode feature is supported only in single switch
(i.e. edge switch) environments. This means that cascading of
switches while in Multiple VLANs mode is not allowed.
Configuring multiple VLANs on a cascaded switch can possibly
result in disconnection of network paths between switches unless
the port used to link the switch (being configured for multiple
VLANs mode) is configured as uplink VLAN port.
Configuring multiple VLANs on cascaded switches can also affect
enhanced stacking because the master switch may not be able to
detect member switches beyond the first cascaded switch.
802.1Q-
Compliant
Multiple VLAN
mode
In this mode, each port is placed into a separate VLAN as an untagged
port. The VLAN names and VID numbers are based on the port numbers.
For example, the VLAN for port 4 is named Client_VLAN_4 and is given
the VID of 4, the VLAN for port 5 is named Client_VLAN_5 and has a VID
of 5, and so on.
The VLAN configuration is accomplished automatically by the switch.
After you select the mode and an uplink port, the switch forms the