Allied Telesis AT-S63 - Manual (Page 503)

AT-S63 Management Software Menus Interface User’s Guide
Section III: VLANs 503
Creating a Protected Ports VLAN
To create a new protected ports VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
2. From the VLAN Configuration menu, type 4 to select Configure
VLANs.
Note
If the menu does not include selection 4, Configure VLANs, the
switch is running a multiple VLAN mode. To change the switch’s
VLAN mode, refer to ”Selecting a VLAN Mode” on page 468.
3. From the Configure VLANs menu, type 1 to select Create VLAN.
The Create VLAN menu is shown in Figure 160.
Figure 160. Create VLAN Menu
4. Type 1 to select VLAN Name.
The following prompt is displayed:
Enter new value ->
5. Type a name for the new protected ports VLAN.
The name can be from one to fifteen alphanumeric characters in
length. The name should reflect the function of the nodes that will
be a part of the protected ports VLAN (for example,
InternetGroups). The name cannot contain spaces or special
characters, such as asterisks (*) or exclamation points (!).
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Create VLAN
1 - VLAN Name ............
2 - VLAN ID (VID) ........ 2
3 - Tagged Ports .........
4 - Untagged Ports .......
5 - Protected Ports ...... No
C - Create VLAN
R - Return to Previous Menu
Enter your selection?