Allied Telesis AT-S63 - Manual (Page 336)

Chapter 18: SNMPv3
336 Section II: Advanced Features
The following prompt is displayed:
Enter Privacy Protocol [D-DES, N-None]:
6. Choose one of the following Privacy Protocols:
D -DES
Select this value to make the DES privacy (or encryption) protocol
the privacy protocol for this User Table entry. With this selection,
messages transmitted between the host and the switch are
encrypted with the DES protocol.
N -None
Select this value if you do not want a privacy protocol for this User
Table entry. With this selection, messages transmitted between
the host and the switch are not encrypted.
If you select None, proceed to step 9.
If you select DES, the following prompt is displayed:
Enter Privacy Password:
7. Enter a privacy password of up to 32 alphanumeric characters.
The following prompt is displayed:
Re-enter Authentication password:
8. Re-enter the password.
9. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Modifying the Storage Type
To modify the Storage Type in an SNMPv3 User Table entry, perform the
following procedure.
1. Follow steps 1 through 5 in the procedure described in ”Configuring
the SNMPv3 User Table” on page 328. Or, from the Main Menu type
5->1->1->8->5.
The Configure SNMPv3 User Table menu is shown in Figure 106
on page 329.
2. From the Configure SNMPv3 Table menu, type 2 to select Configure
SNMPv3 User Table.
The SNMPv3 User Table is shown in Figure 107 on page 329.
3. From the SNMPv3 User Table, type 3 to select Modify SNMPv3 Table
Entry.