Allied Telesis AT-S63 - Manual (Page 394)

Chapter 18: SNMPv3
394 Section II: Advanced Features
3. To create an SNMPv3 Target Parameters Table, type 1 to select Create
SNMPv3 Table Entry.
The following prompt is displayed:
Enter Target Parameters Name:
4. Enter a name of the Target Parameters.
Enter a value of up to 32 alphanumeric characters.
Note
You are prompted to enter a value for the Message Processing
Model parameter only if you select SNMPv1 or SNMPv2c as the
Security Model. If you select the SNMPv3 protocol as the Security
Model, then the Message Processing Model is automatically
assigned to SNMPv3.
The following prompt is displayed:
Enter User (Security) Name:
5. Enter a User Name.
The value of this parameter is previously configured with the
Configure SNMPv3 User Table. See ”Creating an SNMPv3 User
Table Entry” on page 328.
The following prompt is displayed:
Enter Security Model [1-v1, 2-v2c, 3-v3]:
6. Select one of the following SNMP protocols as the Security Model for
this Security Name, or User Name.
1-v1
Select this value to associate the Security Name, or User Name,
with the SNMPv1 protocol.
2-v2c
Select this value to associate the Security Name, or User Name,
with the SNMPv2c protocol.
3-v3
Select this value to associate the Security Name, or User Name,
with the SNMPv3 protocol. The SNMPv3 protocol allows you to
configure the group to authenticate SNMPv3 entities (users) and
to encrypt messages.
The following prompt is displayed: