Allied Telesis AT-S63 - Manual (Page 665)

AT-S63 Management Software Menus Interface User’s Guide
Section IV: Security 665
Configuring Denial of Service Defense
To configure DoS defense, perform the following procedure:
1. From the Main Menu, type 8 to select Security Configuration.
The Security Configuration menu is shown in Figure 175 on page
559.
2. From the Security Configuration menu, type 2 to select Denial of
Service (DoS).
The Denial of Service (DoS) menu is shown in Figure 211.
Figure 211. Denial of Service (DoS) Menu
3. If you are implementing the SMURF or Land defense, you must
provide the IP address of a node connected to the switch and a
subnet mask. For the Land defense, you must also specify an uplink
port. To do this, complete the following steps. Otherwise, go to step 4.
a. Type 1 to select LAN IP Subnet.
The LAN IP Subnet menu is shown in Figure 212.
Figure 212. LAN IP Subnet Menu
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Denial of Service (DoS)
1 - LAN IP Subnet
2 - SYN Flood Configuration
3 - Smurf Configuration
4 - Land Configuration
5 - Teardrop Configuration
6 - Ping of Death Configuration
7 - IP Option Configuration
R - Return to Previous Menu
Enter your selection?
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
LAN IP Subnet
1 - IP Address ................. 0.0.0.0
2 - Subnet Mask ................ 0.0.0.0
3 - Uplink Port ................ 26
R - Return to Previous Menu
Enter your selection?