Allied Telesis AT-S63 - Manual (Page 271)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 271
3 - Point-to-Point
This parameter defines whether the port is functioning as a point-
to-point port. The possible settings are Yes, No, and Auto Detect.
For an explanation of this parameter, refer to ”Point-to-Point and
Edge Ports” on page 255.
4 - Edge Port
This parameter defines whether the port is functioning as an edge
port. The possible settings are Yes and No. For an explanation of
this parameter, refer to ”Point-to-Point and Edge Ports” on page
255.
C - Check Migration To RSTP on Selected Ports (MCHECK)
The MCHECK parameter is displayed only when RSTP is enabled.
This parameter resets an RSTP port, allowing it to send RSTP
BPDUs. When an RSTP bridge receives STP BPDUs on an RSTP port,
the port transmits STP BPDUs. The RSTP port continues to
transmit STP BPDUs indefinitely. Type C to reset the MSTP port to
transmit RSTP BPDUs.
7. After making changes, type R until you return to the Main Menu. Then
type S to select Save Configuration Changes.
Displaying the
RSTP Port
Configuration
To display the RSTP port configuration, perform the following
procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 78 on
page 259.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
The RSTP menu is shown in Figure 79 on page 261.
3. From the RSTP menu, type P to select RSTP Port Parameters.
The RSTP Port Parameters menu is shown in Figure 84 on page
269.
4. From the RSTP Port Parameters menu, type 2 to select Display RSTP
Port Configuration.