Allied Telesis AT-S63 - Manual (Page 381)

AT-S63 Management Software Menus Interface User’s Guide
Section II: Advanced Features 381
6. Enter a UDP port.
You can enter a UDP port in the range of 0 to 65,535. The default
UDP port is 162.
The following prompt is displayed:
Enter Timeout (10mS): [0 to 2147483647]-> 1500
7. Enter a timeout value in milliseconds.
When an Inform message is generated, a response from the
switch is required. The timeout value determines how long the
switch considers the Inform message an active message. This
parameter applies to Inform messages only. The range is from 0 to
2,147,483,647 milliseconds. The default value is 1500
milliseconds.
The following prompt is displayed:
Enter Retries:[0 to 255]-> 3
8. Enter the number of times the switch will retry, or resend, an Inform
message.
When an Inform message is generated, a response from the
switch is required. This parameter determines how many times
the switch resends an Inform message. The Retries parameter
applies to Inform messages only. The range is 0 to 255 retries. The
default is 3 retries.
The following prompt is displayed:
Enter Tag List:
9. Enter a Tag List.
This list consists of a tag or list of tags you configured in a
Configure SNMPv3 Notify Table entry with the Notify Tag
parameter. See ”Creating an SNMPv3 Notify Table Entry” on page
371. Enter a Tag List of up to 256 alphanumeric characters. Use a
space to separate entries, for example:
hwengtag swengtag testengtag
The following prompt is displayed:
Enter Target Parameters:
10. Enter a Target Parameters name.
This name can consist of up to 32 alphanumeric characters. The
value configured here must match the value configured with the