Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 233)

Publication 1398-5.2 – PDF 1997
Appendix C
TouchPad Instructions
Appendix C
The optional TouchPad is a compact and rugged device for interfacing
with ULTRA 100 Series drives. It provides the operator with a
convenient device for accessing status information, program variables,
and control functions, plus message display capabilities on any
ULTRA 100 Series drive.
An 8-character dot matrix display and a sealed-membrane type
keyboard are housed in a compact case. A locking tab and a single 9-
pin D shell serial connector on the backpanel connects the TouchPad
to any ULTRA 100 Series drive via four-wire RS-485
communications.
Four cursor keys and a Mode/Enter key provide access to the
TouchPad menus and enable the user to select and change parameters,
activate commands, and monitor drive variables. The TouchPad also
allows the user to display drive status and diagnostic information, and
to control functions, such as distances, speeds, and other
alphanumeric data.
Installation and Operation
1. Power down the drive.
2. Plug the TouchPad into the serial port on the ULTRA 100 Series
drive by latching the tab into the drive and then mating the con-
nector as shown.
3. Power-up the drive. Installing the TouchPad defaults the drive to
the following settings:
The personality module settings stored in the drive are not
affected by the installation or removal of the TouchPad.
Figure C.1 TouchPad Connection and Pinouts
Intro
1. Insert tab
2. Mate serial connectors
Pin 9
Pin 6
Pin 1
Pin 5
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Pin 7
Pin 8
Pin 9
Receive +
Not used
Not used
Transmit +
+5VDC Common
TouchPad Sense
Receive -
Transmit -
+5VDC
• Address 0 • 1 Stop bit
• 19200 Baud • No Parity bit
• 8 Data bits