Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 234)

Publication 1398-5.2 – PDF 1997
C-2 TouchPad Instructions
4. Verify the Ver##.## displayed is correct at power-up. The version
number designates the type of drive and its firmware level.
Figure C.2 explains this display.
If you are referring to the TouchPad Command Tree card, verify
the version number display and the Drive Type and Firmware
Version of the card are the same.
5. After self-test is completed, the TouchPad display defaults to the
branch title DRVSETUP .
6. Horizontal and vertical movement through the TouchPad Com-
mand Tree and parameter modification is explained below. The
“TouchPad Command Tree
(sheet 1 of 2) ” on page C-4 depicts
the structure of the TouchPad Command Tree.
Figure C.2 TouchPad Version Number Display
Intro
Ver11.10
Drive Type:
1 = 1398-DDM-010 or 1398-DDM-010X,
1398-DDM-020 or 1398-DDM-020X,
1398-DDM-030 or 1398-DDM-030X,
1398-DDM-075 or 1398-DDM-075X,
1398-DDM-150 or 1398-DDM-150X
2 = 1398-DDM-005 or 1398-DDM-005X,
1398-DDM-009 or 1398-DDM-009X,
1398-DDM-019 or 1398-DDM-019X
Firmware Level:
1.00 = Version 1.00
1.10 =
Version 1.10
2.00 = Version 2.00 (Indexing capable)