Rockwell Automation 1398-DDM-xxx ULTRA 100 Series Drives Installation Manual - Manual (Page 76)

Publication 1398-5.2 – PDF 1997
6-12 Interfaces
●
The command input supports 0 to ±10 Volt signals.
Table 6.10: Transistor Output Specifications
Parameter Description Minimum Maximum
ON state Voltage Voltage difference between the external I/O
power supply and the output when the transis-
tor is ON 0 VDC 1.5 VDC
ON state current Current flow when the transistor is ON 0 mA 50 mA
OFF state Voltage Voltage difference between the external I/O
power supply and the output when the transis-
tor is OFF 0 Volts 50 Volts
OFF state current Leakage current from the output when the
transistor is OFF -0.1 mA 0.1 mA
Figure 6.11 Drive Output Connected to an Opto-Isolator
Figure 6.12 Drive Output Connected to an LED Indicator
Figure 6.13 Drive Output Connected to a Resistive Load
Drive J1
I/O Pwr
Pin 13
Pin 6
I/O COM
1K
1K
I/O Pwr
Pin 13
Pin 6
Drive J1
I/O COM
Pin 13
Pin 6
Drive J1
I/O COM
I/O Pwr
1K