Altera PCI Compiler - Manual (Page 238)

5–4 User Guide Version 11.1 Altera Corporation
PCI Compiler October 2011
PCI Compiler with SOPC Builder Flow Design Walkthrough
4. In the New Project Wizard: Directory, Name, Top-Level Entity
page, enter the following information:
a. Type c:\sopc_pci in the What is the working directory for
this project?
box.
b. Type chip_top in the What is the name of the project? box.
1
The Quartus II software automatically specifies a top-level
design entity that has the same name as the project. Do not
change it.
5. Click Next to display the New Project Wizard: Add Files page.
1
When you specify a directory that does not already exist, a
message asks if the specified directory should be created.
Click Yes to create the directory.
6. If you installed the MegaCore IP library in a different directory from
where you installed the Quartus II software, add user libraries by
following these steps on the New Project Wizard: Add Files page:
a. Click User Libraries.
b. Type <path>\pci_compiler\lib\ into the Library name box,
where <path> is the directory in which you installed the PCI
Compiler.
c. Click Add to add the path to the Quartus II project.
d. Click OK to save the library path in the project.
7. Click Next to display the New Project Wizard: Family & Device
Settings
page.
8. In the New Project Wizard: Family & Device Settings page, specify
the following target device family and options:
a. In the Family list, select Stratix II.
1
This walkthrough creates a design targeting the Stratix II
device family. You can also use these procedures for other
supported device families.
b. Under Target device, select Specific device selected in
‘Available devices’ list
.