ATEIS IDA8 - Manual (Page 255)

Product Features 255
© 2012 ATEÏS
Status Frequency Activity
Permanent There are faults in audio processor.
Blinking ° ° Lost communication with audio processor.
4. EVAC Indicator
Light up when the system is under evacuation paging.
Status Frequency Activity
Permanent System is under evacuation paging.
Blinking ° ° PCP does not do a "Plug-in" in Ateis Studio before using.
5. Power Indicator
This LED light up when the PCP is powered on.
6. Microphone Connector
A phone jack connector for connection of telephone styled microphone.
7. Talk Button
Press this button to request paging. There are two modes for this button: push to talk and lock.
8. Talk Indicator
This LED light up if PCP is allowed to paging, on the other word, the paging request has been
acknowledged.
Note: Sometimes even the paging request is granted, zones under paging still can be occupied by
other sources with higher priority. In the event of, the talk LED still lights up, you can check it from
busy LEDs.
9. Hold Indicator(1~8)
These LEDs Indicate which keys are selected.
10.All Call/Release Button
This button is used to select or deselect all keys.
11.All Call/Release Indicator
This indicator lights up if all keys are selected.
12.Event Select Key(1~8)
These buttons are used to select keys, each key may link to an event for triggering actions like
paging or adjust the value of parameters.
13.Busy Indicator(9~16)
Please refer to Busy Indicator(1~8).
14.Hold Indicator(9~16)
Please refer to Hold Indicator(1~8).
15.Event Select Key(9~16)
Please refer to Event Select Key(9~16).