ATEIS IDA8 - Manual (Page 71)

Product Features 71
© 2012 ATEÏS
System Fault LED:
This LED lights up when a system fault fault is detected.
G.Fault LED:
This LED lights up when a global fault is detected.
Bypass Mode LED:
Indicates if the IDA8C is in bypass mode.
Bypass Monitoring LED:
Shows if the monitoring function is enabled. This LED lights up if monitoring of the IDA8 is disabled
by the user.
Global EVAC LED:
Indicates if the system is in EVAC paging state. This LED lights up if any IDA8 device over Ateis
Net is performing EVAC paging. See the topic of Network Paging Component to learn more about
how to configure an EVAC paging.
Zone EVAC LEDs:
Shows the audio channel is in EVAC paging. Each LED corresponds to an output channel of a
Network Paging component. For example, 1st LED is for pin M1, 2nd LED for pin M2 and so on.
Power LED:
This LED lights up when the IDA8S is power on.
Network LED:
Shows the status of the Ateis Net. This LED lights up if there are more than two deployed IDA8
devices in the Ateis Net.
Zone Fault LEDs:
To show fault status of zone. This LED lights up if one of the following faults is detected:
Normal AMP Error
Line Speaker Error
Backup AMP Error
AMP Line Leakage Error