ATEIS IDA8 User Manual
Page 64
ATEIS - IDA8
64
© 2012 ATEÏS
Zone1 Amplifier Output:
This connector is used to connect the output of the zone1 amplifier for receiving the 100V audio
signal powered by the amplifier.
Zone1 Amplifier Input:
This connector is used to connect the input of the zone1 amplifier for transmitting 0dB audio signal
to the amplifier.
Backup Amplifier Input:
This connector is used to connect the input of the backup amplifier for transmitting 0dB audio signal
to the amplifier.
Contact Outputs:
8 logic output channels
to close/open circuits for an external device, this contact is normally open.
Evacuation Inputs:
9 evacuation contact inputs allow the monitoring of external contact. They also can be used in UGA
mode and triggered by a voltage polarization change.
24V DC Output:
This connector supplies a 24VDC source.
24V DC Input:
Main 24VDC power supply connector.
AC Power Socket:
Main 110~240 V 1.2A, 47~63Hz AC power input with fuse. If 24V DC and AC power input at the
same time, IDA8C will use AC power, and switch to DC power if there is no AC power input.
Fuse Rating: 1.6A