ATEIS IDA8 - Manual (Page 88)

ATEIS - IDA8 88
© 2012 ATEÏS
Name Description
3. Line A/B short, a circuit outside the speaker zone output
connector is shorted, and no sound comes out. This fault may
damage the amplifier.
AMP Line Leakage Error The current between the speakers and amplifiers has a leakage.
EVAC Input Error
The voltage of EVAC input is not in the range (when the evacuation
input is set to "contact mode").
AteisNet Broken
This fault happens when one or more IDA8C's or IDA8S's over Ateis
Net lose the connection.
Note: Global Ateis Net Broken only for global net IDA8.
Fireman Error The fireman microphone has an error.
VOX@NET Error The IDA8C/S can't communicate with the VOX@NET server.
Redundancy Error
1. It shows "Backup Device Offline" when a backup device can't
communicate.
2. It shows "Operation Mode Fail" for:
RU device is turned off.
The incorrect wiring between the RU and the IDA8.
Remote Offline
The peripheral devices (PSS AS/PPM AS/URC AS/...)
can't communicate with the IDA8C/S.
URGP Fault The URGP device monitor is out of tolerance
Remote Fault
There is a hardware error of peripheral devices, such as the
microphone/speaker on a PSS.
File Corruption The file CRC check code fails if the file monitor option is enabled.
ModBus Offline The Modbus client can't communicate.
AMP Rating Fault The IDA8 gets the reference value which is too low.
BackupAmp Used State A normal amplifier fails and is replaced by the backup amplifier.
Local AteisNet Backup Mode One of the local ATEIS net port has broken.
Global AteisNet Backup Mode
One of the global ATEIS net port has broken.
Note: Only for global net IDA8.
Bypass Mode
If using a redundancy unit, the IDA8 will enter the bypass mode
when a Bypass Mode fault occurs. If not, the IDA8 will enter in that
mode only when the "Bypass Input" line on the rear panel has
broken.
Major User Define Fault The "Fault Define Security" component trigger.
Minor User Define Fault The "Fault Define Security" component trigger.
Modan Offline The Modan client can't communicate.
NTP Server Error All the NTP server can't communicate.
Normal AMP Out of Toler. The normal amplifier measure out of tolerance.
Backup AMP Out of Toler. The backup amplifier measure out of tolerance.
4.1.7.1.1 Table of System Faults
Name Description
Flash Error An error occurred in the Nand flash inside IDA8C/S.
I2C Error
There is an internal error of I2C communication between micro
controllers.
Net Card Error
There is an error of communication between the main CPU in the
IDA8C/S and the Net card.
DSP Error
There is an internal error of communication between micro
controllers inside devices.
Preset Table Error
The structure of the configuration is not compatible with the current
firmware.
108
109
111
113
114
115
116
118
117
120
121
121
122
123
123
124
125
125
126
127
127
89
89
90
91
91