ATEIS IDA8 - Manual (Page 86)

ATEIS - IDA8 86
© 2012 ATEÏS
The meaning of the parameters are listed below:
Amount:
Specifies the number of backup amplifiers in system. The list content of the combo box in an
amplifier depends on this value. For example, if Amount = 3, then the list content should be
none (zero), 1, 2, 3.
Field [Device] of Grid:
Lists devices within the same Ateis Net.
Field [Zone Board] of Grid:
Lists zone boards of the device. Zone Board1 means Zone1 to Zone4, Zone board2 means
Zone5 to Zone8.
Field [Amplifier] of Grid:
Specifies the group without zones. In the above figure, IDA8S1 Zone board1(Zone1~Zone4 of
IDA8S1), IDA8S2 Zone Board1(Zone1~4 of IDA8S2), IDA8S2 Zone Board2(zone 5~8 of IDA8S2)
are the same value (i.e. those zones are the same group and use the same amplifier for
backup).
4.1.7 Monitoring/Fault
For security purposes, the IDA8 is designed to monitor equipment. When an error is detected, a fault will
be generated to inform the user. The user can then change the non-working equipment quickly to make
the system function correctly again.
There are two types of faults:
System Fault:
This sort of fault is about the internal error of the IDA8C/S. In most of cases, it is a hardware failure
and the board inside the device needs to be changed o repaired.
G.Fault: