ATEIS IDA8 - Manual (Page 34)

ATEIS - IDA8 34
© 2012 ATEÏS
This LED lights up when a global fault is detected.
Note: Fault LED and system fault LED are exclusive. If system fault and global fault are detected at
the same time, the system only light the system fault LED.
System Fault LED:
This LED lights up when a system fault fault is detected.
Global EVAC LED:
To indicate system is in EVAC paging or not. This LED lights up if any IDA8 device over Ateis Net
do an EVAC paging.
Bypass Monitoring LED:
Shows the monitoring function is enabled or not. This LED lights up if monitoring of IDA8 is disabled
by user.
Touch Screen:
3.5" Color touch panel offers a graphical interface for users to control or read the status of system.
There is a multi layered menu on it to get/set parameters or change settings of device.
ESC Button:
To Navigate menu of touch screen.
OK Button:
To Navigate menu of touch screen.
Up Button:
To Navigate menu of touch screen.
Down Button:
To Navigate menu of touch screen.
Plus Button:
To Navigate menu of touch screen.
Down Button:
To Navigate menu of touch screen.
Zone EVAC LEDs:
To show the audio channel is in EVAC paging or not. Each LED corresponds to an output channel of
Network Paging component. For example, 1st LED is for pin M1, 2nd LED for pin M2 and so on.
Zone Fault LEDs:
To show fault status of zone. This LED lights up if one of following faults is detected:
Normal AMP Error