ATEIS IDA8 - Manual (Page 306)

ATEIS - IDA8 306
© 2012 ATEÏS
For each channel, there is an XLR balanced input and a Euro-terminal block balanced input. Each
input can be gain adjusted to suit the user’s needs. The On/Off gain switch can instantaneously
bypass the gain controller and set the channel gain amplifier to maximum.
AC Power Inlet:
The 3 pin IEC connector is located on the left of the amplifier’s rear panel. It accepts a standard
mains power lead fitted with an IEC connector.
For 115 V, fuse rating:
SPA 2060: 2.5A
SPA 2120: 5A
SPA 2240: 8A
For 230 V, fuse rating:
SPA 2060: 1.25A
SPA 2120: 2.5A
SPA 2240: 5A
Channel 1/2 Audio Output:
For each amplifier channel, there is a dedicated Audio Output connector for connection of either 8
Ohm speakers, 75V speakers or 100V speakers. For the 8 Ohm connection and if you are using
more than 1 speaker, please ensure that speakers are wired in a way that the total impedance load
is between 8 Ohm and 16 Ohm. The Com point is the negative terminal and 8 Ohm, 75V and 100V
are the positive terminals.
Fault Contact:
The fault contact indicates an amplifier fault by an opening contact.
Channel 1/2 Inputs GAIN and ON/OFF switch:
The on/off switch is mainly for the parallel output and the knob is for adjusting the amplifier gain.
4.3.1.4 Characteristics
Case:
Dimension:
o SPA2060, SPA2120 = 425mm (W) x 305mm(D) x 88mm(H)
o SPA2240 = 425mm (W) x 420mm(D) x 88mm(H)
Weight :
o SPA2060 = 10.6 Kg
o SPA2120 = 12.3 Kg
o SPA2240 = 18.5 Kg
Color = RAL7016.