Super Systems PC Configurator 2 - Manual (Page 106)

Super Systems Inc. Page 106 of 201 Configurator Manual #4562 Rev D
Alarm 3 Event 12 IN3 relay SPC
Event 0 Event 13 alarm combination
Event 1 Event 14
Event 2 Event 15
The “Alarm Combination” option will allow the user to select the specific combination of alarms
to use.
Configurator – Alarm Combination options
Relay Setpoints
Configurator – Relay Setpoints menu option
This option is typically used for vacuum applications.
The 9200 dual Loop controller offers the user three pairs of configurable vacuum setpoints for
each input. Each pair of setpoints allows the user to configure both ON and OFF trigger points.
The values entered are in engineering units based on input configuration.