Super Systems PC Configurator 2 - Manual (Page 61)

Super Systems Inc. Page 61 of 201 Configurator Manual #4562 Rev D
The “Number of Words to Send” box will allow the user to set the number of words to send
with each write. The range is 0 to 150.
The “Target” box will allow the user to set the target for the write. This will be the target
register to begin the write process to on the selected slave instrument. The range is 0 to
32,767.
The Apply button will set any changes made in the “Block Write Table” section.
IP Address Table Section
This section of the form allows the user to set up the IP address and ports for the slave
instruments. The IP addresses will be located in the “Port” drop-down list on the
Slave
Instrument Setup menu option screen. Note: Currently, only IP Address 1 – IP Address 4 is
available in the 9005 controller for the “Port” option . The drop-down list will allow the user to
select which IP address to set up. The options are: IP 1 – IP 16. Note: If any changes have
been made to the current IP Address, the user will have the option to save the changes before
the new IP Address is selected .
Configurator – Confirm Save Changes to IP Address
Clicking on the Yes button will save the changes and select the new IP Address. Clicking on
the No button will not save any changes and it will select the new IP Address.
The four boxes separated by periods -
- will allow the user to
enter the IP Address. The range for all four boxes is 0 to 255.
The “Port” box will allow the user to set up the port for the IP Address.
Note: The port will
typically be 502 . The range is 0 to 100,000.
The Apply button will set any changes made in the “IP Address Table” section.