Super Systems PC Configurator 2 - Manual (Page 87)

Super Systems Inc. Page 87 of 201 Configurator Manual #4562 Rev D
Event Run Program Setup
Configurator – Event Run Program Setup menu option
Event run program setup is used to start a program that is stored in the 9200 dual loop
controller (zero for buffered) or by a defined event input.
*Program must be configured under the menu option Event Control
*Used to define an event input to initiate a program start and to define which program
to start (zero starts the last program run) from the contact closure. The range of
programs to run is 0 to 300.
*WARNING*
If a JUMP (to another program) is used in a previous program, the program that will run would
be the last program jumped to not the first program run.
If you stop a program in a GOSUB the program that will be run will be the GOSUB.