Super Systems PC Configurator 2 - Manual (Page 132)

Super Systems Inc. Page 132 of 201 Configurator Manual #4562 Rev D
TC Extension Correction Curves
Configurator – TC Extension Correction Curves menu option
This menu option will allow the user to set up to three TC correction curves for the 9200
controller. Clicking on the “click” value for a curve will display the curve edit form.
Note: If the
first “Temperature” value and the first “Error” value are both zero, then the curve will not be
set . The user can enter up to ten “Temperature”/“Error” combinations. The range for the
“Temperature” field is –300 to 9999. The range for the “Error” field is –30.000 to 30.000.
Configurator – Curve edit form