Super Systems PC Configurator 2 - Manual (Page 145)

Super Systems Inc. Page 145 of 201 Configurator Manual #4562 Rev D
D.A. Ctrl by Valve 3:
This option will determine if the D.A. (Disassociated Ammonia) can be controlled by valve 3.
The options are: No or Yes.
Aux gas Ctrl by Valve 4:
This option will determine if the auxiliary gas can be controlled by valve 4. The options are: No
or Yes.
Temperature Mode:
This option will set the temperature mode for the controller. The options are:
°F (Degrees
Fahrenheit) or °C (Degrees Celsius).
Leak Up Event (0 Disables):
This option will allow the user to set the leak up event number. The range is: 0 to 48.
Leak Up Rate, Max
µ/hr:
This option allows the user to set the maximum leak up rate. The range is: 0 to 65.
Leak Up Retries, Max:
This option allows the user to set the maximum number of retires for the leak up process. The
range is: 0 to 500.
Leak Up Vacuum Gauge:
This option will allow the user to set the leak up gauge number. The range is: 1 to 4.
Default Wait Limits
*** This menu option is the same as the Default Wait Limits menu option under the
Configurator-9200 Drop-Down Menu . ***
Alarm Setup
*** This menu option is the same as the Alarm Setup menu option under the Configurator-9200
Drop-Down Menu . ***
Relay Assignments
*** This menu option is the same as the Relay Assignments menu option under the
Configurator-9200 Drop-Down Menu . ***
Relay Setpoints
*** This menu option is the same as the Relay Setpoints menu option under the Configurator-
9200 Drop-Down Menu . ***
Analog Input Setup
*** This menu option is the same as the Analog Input Setup menu option under the
Configurator-9200 Drop-Down Menu . ***