Super Systems PC Configurator 2 - Manual (Page 40)

Super Systems Inc. Page 40 of 201 Configurator Manual #4562 Rev D
Locate IP – Initial screen
30 – Identify the controller being upgraded by its serial number. The serial number will be the
last item on the “Response from” line.
31 – Click the Configure button on the upper left side of the screen. Use the drop-down menu
to identify the controller being upgraded. Click on the controller. Click on the OK button to the
right of the drop-down menu. Make a note of the IP Address.
Locate IP – Configure screen
Locate IP – Configure screen 2
32 – Manually change the IP address to match the following:
IP
address 192 168 1 200
Net Mask 255 255 255 0
Gateway 192 168 1 1
33 – Click the OK button to close the configuration screen, and then click the Exit button to
exit from the Locate IP software program.
34 – Go To, or start, the Serial Number Utility software on you PC.
35 – In the “Media” section of the form, use the drop-down menu to select “Ethernet”.