Super Systems PC Configurator 2 - Manual (Page 78)

Super Systems Inc. Page 78 of 201 Configurator Manual #4562 Rev D
Click on the OK button to set the new value, or click on the Cancel button to cancel.
Burnoff Recovery Wait Time:
The amount of time allotted to allow the probe measurements to return to a stable, accurate
range after the burnoff is complete. This is measured in seconds. The control output is held
until this time is elapsed. Clicking on the value will allow the user to change the value.
Burnoff Interval:
The amount of time between the beginning of one burnoff and the beginning of the next
scheduled burnoff measured in minutes. Clicking on the value will allow the user to change the
value.
Burnoff Minimum Millivolts:
The minimum measured millivolt tolerance of the probe required to start a burnoff. Clicking on
the value will allow the user to change the value.
Burnoff Maximum Temperature:
The maximum measured temperature allowed during a burnoff. If the temperature value is
exceeded
the burnoff will stop . This is done to help maintain the life and the accuracy of
your probe. Clicking on the value will allow the user to change the value.
Digital IN 4 Assignment:
The value for the digital input 4 assignment. Clicking on the value will allow the user to change
the value, which can be either event or start BO.
PID Loop Setup
PID is the tuning parameters entered for each Process Variable loop. The loop value can either
be Loop 1, Loop 2, or Loop 3.