Super Systems PC Configurator 2 - Manual (Page 121)

Super Systems Inc. Page 121 of 201 Configurator Manual #4562 Rev D
Enable allows the user to manually turn the valve on or off. The options are Yes or No.
Output:
This is the measured output shown as a percentage, and it cannot be modified.
Trim Enable:
Trim Enable allows the user to manually turn the trim on or off. The options are Yes or No.
Target Setpoint:
This is measured in units of flow (scfh). Clicking on the value will display an input box from
which the user can select a new setpoint. The range is 0 to 4000.
Trim Range:
The allowable specified range of control with the trim enabled - typically set in the program.
Clicking on this value will display an input box from which the user can select a new Trim
Range. The range is 0 to 10000.
Use Curve:
This option manually turns on or off the custom curve entered in the
Curve Entry menu option.
The options are Yes or No.
Input Type:
Clicking on this value will display a drop down menu with the following choices:
voltage
mA / 124 ohm
mA / 249 ohm
mA / 499 ohm
Valve Max:
This is the maximum valve range in units. Clicking on this value displays an input box from
which the user can select a new maximum value. The range is 100 to 30000.