Super Systems PC Configurator 2 - Manual (Page 74)

Super Systems Inc. Page 74 of 201 Configurator Manual #4562 Rev D
This value shows the remaining time, in seconds, for the Burnoff / Impedance Test /
Recoveries.
MV:
This value is a display of the current millivolt input value during a burnoff or impedance test.
TC:
This value is a display of the current probe thermocouple input value during a burnoff or
impedance test.
Start mV:
This value is a display of the millivolt input value at the beginning of the Burnoff or impedance
test.
.
Start TC:
This value is a display of the probe thermocouple value at the beginning of the burnoff or
impedance test.
Last Burnoff:
This value shows the date and time of the last burnoff.
Last Impedance Test:
This value shows the date and time of the last Impedance test.
Last Recovery:
This value is a display of the time in seconds it took the millivolt input to return to 1% of the
Start mV.
Last Min mV:
This value is a display of the minimum millivolts measured during the last burnoff or impedance
test.
Last Impedance:
This value is a display of the measured resistance, in Kohms, after the last impedance test.
Last Max TC:
This value is a display of the maximum measured probe thermocouple input value during the
last burnoff.
Slave Instruments
This page is a display of the current process variables of each of the slave instruments
communicating with the 9200 dual loop controller.
Note – None of these values can be
modified on this screen .
For set-up of the auxiliary instruments go to the menu item “ Slave Instrument Setup ”